Blue Point Switch Machine Installation
Blue Point Switch Machine Installation. Specs we’ve designed the blue point™ turnout control to operate turnouts in scales from n through o. The electrical contacts are double pole, double throw (dpdt) rated at 5 amps, so they have plenty of capacity to power a frog or just about.
A system that do not compromise traffic regularity, but uses the latest technology to heat only when it is needed. Attach them to the benchwork under the turnout, then use our system to connect the blue point™ to the fascia knob. This is very important for correct blue point mounting alignment.
Wire In Minutes With Included Cables.
Bluepoints are easy to install, require little or no wiring depending on turnout types and other options you may have (signals, indicator lights,. Tortoise and switch master are the old favorites in terms of stall motors. This is special drill used to make flush cut hole completely through.
Attach Them To The Benchwork Under The Turnout, Then Use Our System To Connect The Blue Point™ To The Fascia Knob.
* includes two sets of electrical contacts for frog, signals or other electronics dependent on the turnout position Posted by bob@osd on tuesday, may 15, 2007 1:39 pm. Screw the switch plug into the switch bulkhead until the button bottoms out, then back off one turn.
1) These Days There Is An Electronic Circuit Board Commercially Available Called A Frog Juicer. It Does The Same Job As The Micro Switch Did On The Club Layout.
This is very important for correct blue point mounting alignment. * suitable for all scales The small hex nut is not needed for operation and can be discarded.
#1 Remove Ground Throw Unit From Switch.
#11 · mar 10, 2022. When you are happy, just cut hole in the foam for the tortoise and drop it in with the 1/8 inch board being the height of the roadbed. Part of the magic of model railroading is being able to control turnouts by throwing a remote switch or control lever so that your trains can navigate over t.
2A #2A Drill Second Hole Centered Between Rails Through Bench Work At Point Shown In Picture.
The electrical contacts are double pole, double throw (dpdt) rated at 5 amps, so they have plenty of capacity to power a frog or just about anything else you'll want to drive. It is commonly reported that switchmasters will last for years, in some cases decades. * use flex link tubing and hardware to hook up and control blue point machines, available from new rail models (sold separately) additional product information.
Post a Comment for "Blue Point Switch Machine Installation"