Antari Fog Machine Troubleshooting
Antari Fog Machine Troubleshooting. Antari low fog machine congratulations on the purchase of your new antari fog machine. Before taking your machine in for a service, there are a few steps you can troubleshoot on your own.
Antari low fog machine congratulations on the purchase of your new antari fog machine. (refer to figure 4) fill antari fll low fog effects fluid to the tank, tighten the tank cap. It will heat up and the nozzle gets hot but no fog will come out aside from the drizzle during warm up.
Run The Machine Briefly To Clear Any Cleaning Solution From The Pump And Heater.
Connect the machine with the black fog conducting hose; Connect the machine with the black fog conducting hose; Www.antari.com setting up step 1:
Connect The Machine To A Suitably Rated Power Supply.
The output nozzle becomes hot during operation. The length of the pipe can be adjusted to fit the actual need. I have another one of these fog machines that's working fine, so what i'll do before any further testing and shorting, is swap out the pump and pcb from this working unit.
Place The Machine On A Flat Surface And In A Suitably Large Area With At Least 50 Cm Of Open Space Around The Machine.
(refer to figure 4) fill antari fll low fog effects fluid to the tank, tighten the tank cap. Remote operation is possible up to a distance of 50 meters. Fog fogger jet weatherproofed battery powerded.
Charge The Battery By Plugging The Charger Adaptor Into A Grounded Electrical Outlet.
Never try to repair this product, an Place the machine on a flat surface and in a suitably large area with at least 50 cm open space at each side of the machine and 5 meters for the output direction of the machine. Connect the machine to suitably rated power supply.
(Refer To Figure 5) Figure4 Figure5 Operation 1.
The output was not up to par. Fill the fluid tank with antari approved fluid. Remove machine from battery or power adaptor and clean with a damp cloth.
Post a Comment for "Antari Fog Machine Troubleshooting"